Cellular network
A cellular network is a radio network made up of a number of radio cells (or just cells) each served by a fixed transmitter, known as a cell site or base station. These cells are used to cover different areas in order to provide radio coverage over a wider area than the area of one cell. Cellular networks are inherently asymmetric with a set of fixed main transceivers each serving a cell and a set of distributed (generally, but not always, mobile) transceivers which provide services to the network's users.
Cellular networks offer a number of advantages over alternative solutions:
- increased capacity
- reduced power usage
- better coverage
A good (and simple) example of a cellular system is an old taxi driver's radio system where the taxi company will have several transmitters based around a city. We'll use that as an example and assume that each transmitter is handled separately by a different operator.
Contents |
General characteristics
The primary requirement for a network in the cellular concept is a way for each distributed station to distinguish the signal from its own transmitter from the signal from other transmitters. There are two common solutions to this, frequency division multiple access (FDMA) and code division multiple access (CDMA). FDMA works by using a different frequency for each neighboring cell. By tuning to the frequency of a chosen cell the distributed stations can avoid the signal from other cells. The principle of CDMA is more complex, but achieves the same result; the distributed transceivers can select one cell and listen to it. Other available methods of multiplexing such as polarization division multiple access (PDMA) and time division multiple access (TDMA) cannot be used to separate signals from one cell to the next since the effects of both vary with position and this would make signal separation practically impossible. Time division multiple access, however, is used in combination with either FDMA or CDMA in a number of systems to give multiple channels within the coverage area of a single cell.
In the case of our taxi company, each radio has a knob. The knob acts as a channel selector and allows the radio to tune to different frequencies. As the drivers move around, they change from channel to channel. The drivers know which frequency covers approximately what area, when they don't get a signal from the transmitter, they also try other channels until they find one which works. The taxi drivers only speak one at a time, as invited by the operator (in a sense TDMA).
Broadcast messages and paging
Practically every cellular system has some kind of broadcast mechanism. This can be used directly for distributing information to multiple mobiles, commonly, for example in mobile telephony systems, the most important use of broadcast information is to set up channels for one to one communication between the mobile transreceiver and the base station. This is called paging.
The details of the process of paging vary somewhat from network to network, but normally we know a limited number of cells where the phone is located (this group of cells is called a location area in the GSM system or Routing Area in UMTS). Paging takes place by sending the broadcast message on all of those cells. Paging messages can be used for information transfer. This happens in pagers, in CDMA systems for sending SMS messages, and in the UMTS system where it allows for low downlink latency in packet-based connections.
Our taxi network is a very good example here. The broadcast capability is often used to tell about road conditions and also to tell about work which is available to anybody. On the other hand, typically there is a list of taxis waiting for work. When a particular taxi comes up for work, the operator will call their number over the air. The taxi driver acknowledges that they are listening, then the operator reads out the address where the taxi driver has to go.
Further Reading
For any further related information on the subject refer to Wikipedia Cellular network
